Improper use of the power point outlet can cause damage not covered by your warranty. Block the wheel that is diagonally opposite of the flat tire using the wheel chock provided with your vehicle. Opening the liftgate window Press to unlatch the liftgate window. Do not tow your vehicle with all wheels on the ground unless you install the neutral tow kit as vehicle damage may occur. Connect the negative - cable to the negative - terminal of the assisting battery.
Always drive and ride with your seatback upright and the lap belt snug and low across the hips. Your keys are programmed to your vehicle; using a non-programmed key will not permit your vehicle to start. To access this information, special equipment must be directly connected to the recording modules. Special materials and procedures have been developed for flexible fuel vehicles and the dispensers used by ethanol fuel providers. Appreciate the experience of the car or truck, along with the house is great for people with little ones who choose to just take highway excursions or driving holidays. This doesn't allow much room really but I didn't have a fitting to remove the seat belt from the top of the vehicle to completely remove the panel. If a light fails to illuminate, have the vehicle serviced.
I ran the goo all the way around the speaker making sure that I sufficiently overlapped the outter cone with the metal rim. These comments should be read and observed. Ford Motor Company has not approved a slingbelt towing procedure. If this warning stays on, contact your dealer as soon as possible. The memory seat control is located on the driver door. Running out of fuel Avoid running out of fuel because this situation may have an adverse affect on powertrain components. Grasp the bulb only by its plastic base and do not touch the glass.
Our 2004 Ford Explorer repair manuals include all the information you need to repair or service your 2004 Explorer, including diagnostic trouble codes, descriptions, probable causes, step-by-step routines, specifications, and a troubleshooting guide. Side 1—2: Works in tape mode only. Refer to the Warning Light section in the Instrument Cluster chapter. Pull back the slider panel on the seatback to release the closeout panel. We do not recommend taking fuel economy measurements during the first 1,600 km 1,000 miles of driving engine break-in period. Locate the vertical adjuster for each headlamp.
This mode should be used any time a child safety seat is installed in a passenger front or outboard rear seating position if equipped. Set the highest fan speed. The wrench will stop moving and forward resistance to turning will be felt when properly engaged. For example, if the vehicle is stationary over night with the outside temperature significantly lower than the daytime temperature, the tire pressure may decrease approximately 3 psi 20. To put seat in upright position: 1.
Do not allow people to ride in any area of your vehicle that is not equipped with seats and safety belts. Driving with the parking brake on will cause the brakes to wear out quickly and reduce fuel economy. Return the cover plug to the access hole. Ford recommends the use of a child safety seat having a top tether strap. Power steering fluid reservoir 4.
Lift slightly and remove from truck wall. Some drivers may notice a slight movement of the brake pedal when the AdvanceTrac performs a system self-check. Insert the belt tongue into the proper buckle the buckle closest to the direction the tongue is coming from until you hear a snap and feel it latch. Rotate the seatback downward into the load floor position. Remove the two screws and lamp assembly from vehicle. In some states in the U. If the light is blinking, engine misfire is occurring which could damage your catalytic converter.
Some oil must be removed from the engine by a service technician. Always disconnect the battery before servicing high current fuses. The resulting figure equals the available amount of cargo and luggage load capacity. Ford may change the contents without notice and without incurring obligation. Refer to Lubricant specifications in the Capacities and specifications chapter. Failure to maintain your vehicle properly may void the warranty, increase your repair cost, reduce vehicle performance and operational capabilities and adversely affect driver and passenger safety.
Your oil life is now reset. Turn the blade at an angle from the wiper arm. Do not exceed the Ford Motor Company recommended pressure even if it is less than the maximum pressure allowed for the tire. I will look up there in the morning and hope for the best. Rotate the wrench socket out from the handle. Press lightly on the accelerator in each gear. Routine maintenance of the Personal Safety System is not required.