Minimum tire lift provides maximum stability. Use Mopar Vinyl Cleaner to clean vinyl or leather upholstery. Using a rubber mallet, carefully tap the knuckles from the outside edge. This system monitors the performance of the emissions, engine, and automatic transmission control systems. Improper alignment will not normally cause vehicle vibration, which may be a result of tire and wheel out-of-balance. Parking Lights, Instrument Panel Lights, and Headlights Turn the end of the multi-function control lever to the first detent for parking lights and instrument panel.
Make certain the blocks on the side bows line up with the retainers on the door rails. This ebooks file was hosted in www. If you press the switch a second time, you will turn the defogger off. Other- wise, damage to the steering column or shifter could result. Interior Care Use Mopar Fabric Cleaner to clean fabric upholstery and carpeting.
Operation is subject to the following conditions: 1. Remove the screws attaching the lens to the tailight housing. After the top is folded down, ensure that the drip rail retainers are tucked in inward as shown. Every state in the United States and all Canadian provinces require that small children ride in proper restraint systems. When parking your vehicle, always leave a manual transmission in first gear and apply the parking brake fully to guard against vehicle movement and possible injury or damage.
Cleaning products are available through your authorized dealer. Lock the blocks in place. Exit the vehicle, and go to the rear of the vehicle. Skipping will not damage the disc or the player, and play will resume automatically. Do not ride with the seatback reclined so that the shoulder belt is no longer resting against your chest. Release the Sunrider pins to release the top bows from the brackets located on both door rails. If your foot is not firmly on the brake pedal, the vehicle could accelerate quickly forward or in re- verse.
The blower speed will increase as the knob is turned clockwise. The air cleaner can provide protection in the case of engine backfire. All occupants should use their lap and shoulder belts properly. You can always go back and print what you want anytime youd like. Inspect the engine air filter element, replace if necessary. Wrap strap around sport bar and hook to header and tighten. Lubricate the steering and suspension ball joints.
R Reverse For moving the vehicle rearward. This number can be obtained from your authorized dealer. Additional traction and maxi- mum pulling power for loose, slippery road surfaces only. But in a collision, the belt will lock and reduce the risk of your striking the inside of the vehicle or being thrown out. Grasp the drip rail retainers and untuck both of them starting at the rear of the door frame slot. Repeat this step for the other side. The lower red zone indicates that battery charge may be too low to start the engine.
This is referred to as Automatic Calibration. Also, a slight amount of airflow may be noticed at the defrost outlet located at the base of the windshield. See your dealer for proper diagnosis of the problem. Look up at the 3 bow and locate the 4 snaps on the 3 bow. Never use P Park position with an automatic trans- mission as a substitute for the parking brake. Tuck the retainer around the corner and continue forward.
Begin working from the rear of the vehicle with the tailgate open. Economy— Improper inflation pressures can cause uneven wear patterns to develop across the tire tread. Start at the back of the rear drip rail retainer and work forward towards the windshield. Hood Latch Location Next, locate handle in middle of the front end of the hood. Unclip and move the sun visors to the side. A two-point pivot system allows for horizontal and vertical adjustment of the mirror. This could overheat the brakes and result in unpredictable braking action, longer stopping distances, or brake damage.
The seat belt latch plate is above the back of the front seat, next to your arm in the rear seat. This will weaken the fabric. Repeat this step for the other side. Defrosters Check operation by selecting the defrost mode and place the blower control on high speed. Fully engage the header latch. If the soft top is on the vehicle, proceed to step 5. Forces the front and rear wheels to rotate at the same speed.
If you see any signs of cracking, scuffing, or worn spots, have the brake hoses replaced immediately. Every single element of service, repair and maintenance is included in this fully updated workshop manual. Drive moderately during the first 300 miles 500 km. Damage to the top may result. Play will begin at the start of track 1.