This article applies to the Honda Accord 1990-2002. Test drive vehicle and check for abrupt shifting. When equipped with a six-cylinder engine, the 2010 Honda Accord requires 4. Use the right fluid and replace the filter if applicable. Honda Civic Year Manual Transmission Capacity Manual Transmission Type Automatic Transmission Capacity Automatic Transmission Type 2001 - 2003 1. When the plug is removed, transmission fluid will pour out, so have a bucket handy.
The five-speed B97A automatic transmission requires 8 qts. Once all the fluid drains, re-install the drain bolt with a new washer. If the transmission fluid level in your Civic is low, you need to add transmission fluid through the dipstick tube. If you can't get the fill bolt off you will have to use the transmission dipstick tube to fill it which takes a while and requires some creativity. Avoid that travesty by replacing the clutch and flywheel on your Honda. Don't use a transmission flush machine: it might seem like a faster way, but the extra additives in a power flush can do damage to a transmission.
Honda has a patten on there fluid which includes an additive that is designed for there transmission. For the B90A automatic transmission, 6. Changing your manual transmission fluid is a great way to do both. What type of transmission fluid you need depends on your vehicle. Honda has been developed sophisticated transmissions through years and it is critical that you add the exact type of transmission fluid stipulated by your owner's manual typically in the back of the manual in a section titled Fluid Capacities. Do not flush, Honda states this is not good, and they are correct. Make sure every gear works as it should.
If the fluid is high, bleed out some transmission fluid. The clutch in your Honda. If the transmission fluid level on your Civic is low, you need to add fluid through the dipstick tube. This article applies to the Honda Civic 1992-2000. The procedure is as follows: 1. J ack the front of the vehicle using a hydraulic jack and secure with jack stands. This article applies to the Honda Accord, and Civic 1992-2000.
I was on top of that one and will probably have it done again this time next year. The timing belt and water pump was done when it was supposed to, along with the rest of the belts and the valve cover gasket while everything was apart. Use a funnel and clear plastic tube to refill your transmission fluid. Pour each bottle of down the funnel. Remove drain plug and let transmission drain. The 2010 Accord with the four-cylinder engine takes 4. Slide the end of the tube into the fill bolt hole and make sure it isn't too loose, so it won't come out while filling.
To see the complete guide, please click the link below:--- --------------- This should help. I suggest only changing not flush unless advised to do so by the manufacturer or someone like transman. I agree to be sure to use Honda brand fluid in this Civic auto trans. Other brands claim that there product is compatible. The clutch in your Honda. If there's a hesitation or hard shifting, check the transmission fluid dipstick. Drain, refill, start engine, put in gear, run up to 2500 rpm and let transmission shift all the way up and torque converter lock, brake to zero gently and repeat run up 4 times.
Shift to park and turn off the engine. Turn it clockwise to loosen. Note: Flushing is not the same as changing. Just pull the plug and drain, then refill. I want to remedy the fluid situation, but my research has left me wondering what the best move is.
Here is a list of manual and automatic transmission fluid types and capacities for a Honda Civic. Attach the clear tubing to the funnel and make sure it's a snug fit. To completely flush the transmission fluid, perform Step 2 through Step 4 three times. For the B97A automatic transmission 8 qts. Honda recommends flushing the fluid in automatic transmissions every 60,000 miles.
Click on this article, and find out how to fix the shaking in your clutch. When adding transmission fluid to your Civic, be sure to add it slowly as it will fill up quickly and is difficult to remove excess fluid if you overfill. Find out how to do just that here. Drop the end of the tubing down to the fill hole. Dispose of any old or excess transmission fluid at an approved recycling center.