Each time you start your vehicle, the SecuriLock key is read by the SecuriLock passive anti-theft system. Your vehicle is not equipped with the Ford Ambulance Preparation package. Refer to the Scheduled Maintenance Guide for the service interval schedules. Ford may change the contents without notice and without incurring obligation. Tape direction will automatically reverse when the end of the tape is reached.
It's a lot of money! When I declined he told me I had to sign a lot of paperwork releasing Zeigler from liability. Add fluid until the level reaches the step in the reservoir. Turn the heater fan on in both vehicles to protect any electrical surges. This feature enables the audio playing media to continue playing up to 10 minutes after the ignition has been turned off, or until a door is opened. Refer to the Scheduled Maintenance Guide for service interval schedules. Disengage the clutch, apply brake and shift into N Neutral.
This will eliminate excessive downshifting and upshifting for optimum fuel economy and transmission cooling. Some cold weather knock as of late but thats been all. Install the bulb socket in the foglamp turning clockwise. I told him to bring the papers and a pen. After a few minutes, select any desired position. Do not start the engine when your vehicle is on the jack. Reproduction by any means, electronic or mechanical including photocopying, recording or by any information storage and retrieval system or translation in whole or part is not permitted without written authorization from Ford Motor Company.
Put the gearshift in P Park automatic transmission or the neutral position manual transmission , turn off all accessories and start the engine. Pressing the control for more than three seconds results in fast rewind. Using the manual lumbar support Turn the lumbar support control toward the front of vehicle to increase firmness. Refer to the Scheduled Maintenance Guide for the appropriate intervals for changing the fuel filter. Follow the same steps to replace either bulb: 1. Upshifts can be made by shifting to 2 Second or to Overdrive.
Open the liftgate to expose the lamp assemblies. The jack is only meant for changing the tire. Map out your route before driving in the area. This system meets all Canadian Interference-Causing Equipment standard requirements regulating the impulse electrical field strength of radio noise. View the options for your vehicle by entering your make and model in our easy look-up system.
Allow the safety belt to retract to remove any slack in the belt. Once speed control is switched off, the previously programmed set speed will be erased. . Department of Transportation requires Ford to give you the following information about tire grades exactly as the government has written it. For more information on top tether straps, refer to Attaching safety seats with tether straps.
Start the engine of the disabled vehicle. Follow the instructions on the cleaner label. Illumination of the charging system warning light, Check Engine indicator light or the temperature warning light, fluid leaks, strange odors, smoke or loss of oil pressure, could indicate that the emission control system is not working properly. If fuel is splashed in the eyes, remove contact lenses if worn , flush with water for 15 minutes and seek medical attention. The automatic locking mode is not available on the driver safety belt. Stow the jack and lug wrench. Disconnect the electrical connector from the foglamp bulb.
Use a screwdriver to pry the spring clip on each connector past the head of the support screw. Do not tow with a slingbelt. Insert the belt tongue into the proper buckle the buckle closest to the direction the tongue is coming from until you hear a snap and feel it latch. Install and tighten the fill plug securely. If your vehicle requires professional service, your dealership can provide necessary parts and service. The normal operating temperature can be reached after approximately 30 km 20 miles of driving.
The pressure in an overfilled tank may cause leakage and lead to fuel spray and fire. Insert the belt tongue into the proper buckle the buckle closest to the direction the tongue is coming from for that seating position until. To adjust your mirrors: 1. Shift the transfer case to N Neutral. It does not include passengers or aftermarket equipment. Release clip and disconnect the electrical connector from the bulb.