Damage to the catalytic converter can result if your vehicle is not kept in proper operating condition. Hood Release Outside of the vehicle, locate the safety latch lever near the center of the grille between the grille and hood opening. Install the bulb and connector assembly into the fog light housing and rotate the connector to lock it in place. In a collision, an unrestrained child, even a tiny baby, can become a missile inside the vehicle. If your vehicle has tires of a different size than the size indicated on the vehicle placard or tire inflation pressure label, you should determine the proper tire inflation pressure for those. Inspect these ball joints when other maintenance is performed.
Unapproved modifications or service procedures to the front seat assembly, its related components, or seat cover may inadvertently change the airbag de- ployment in case of a frontal crash. Adjusting a seat while the vehicle is moving is dangerous. The load must not exceed 150 lbs 68 kg , and it should be distributed uniformly over the cross rails. Adjust any seat only while the vehicle is parked. An improperly adjusted weight distributing hitch system may reduce handling, stability, braking performance, and could result in an accident. Rear Mode Control Turn to select Panel, Bi-Level, or Floor for the mode of rear cabin air distribution.
Beverage Cooler Operation The blower speed setting on the climate control sets the rate at which air flows into the compartment. Have the deflated flat tire repaired or replaced as soon as possible. If the Vehicle Security Light turns on during normal vehicle operation vehicle running for longer than 10 seconds , it indicates that there is a fault in the electron- ics. The foot operated parking brake is positioned below the lower left corner of the instrument panel. The automakers will try to change this in the very near future.
The seat belt latch plate is along side the pillar near the back of your seat. A child could be badly injured. Failure to follow this warning may result in personal injury. When navigating through an automated system such as voice mail, or when sending a page, at the end of speaking the digit string, make sure to say Send. Overfilling the engine will cause oil aeration, which can lead to loss of oil pressure and an increase in oil temperature.
Used oil and oil filters, indiscriminately discarded, can present a problem to the environment. Sudden loss of visibility through the windshield could lead to an accident. Check for stones, nails, glass, or other objects lodged in the tread. Recirculation Mode Control Press and release to change the current setting. Relying too much on your passenger-side convex mirror could cause you to collide with another vehicle or other object. Minimum tire lift provides maximum stability.
Do not attempt to push or tow your vehicle to get it started. After the Ready prompt and the following beep, say Dial. Do not check oil level before starting the engine after it has sat overnight. Do not touch the new bulb with your fingers. The lower anchors are round bars located at the rear of the seat cushion where it meets the seatback and are just visible when you lean.
You could accidentally set the system or cause it to go faster than you want. The system will provide mechanical steering capability if power assist is lost. An incorrectly anchored tether strap could lead to increased head motion and possible injury to the child. Left Front Temperature Control Provides left front seat occupant with independent tem- perature control. Then turn the Left Front Temperature Control to dial in the tem- perature that you want the system to maintain for all three zones.
Change Engine Oil The oil change indicator system will remind you that it is time to take your vehicle in for scheduled maintenance. Damage to the fuel system or emissions control system could result from using an improper fuel tank filler tube cap gas cap. Be certain that the seatback is locked securely into position. This could damage your engine. Replace the air conditioning filter if equipped. A single chime will sound to signify that you have success- fully completed the programming. To loosen the lap belt if it is too tight, tilt the latch plate and pull on the lap belt.